Powertrax No-Slip Traction System User Manual Manual de usuario descargar pdf (Pagina 21)

Disassemble the Powertrax No-Slip Tracon System for inspecon by reversing the instal-

laon procedure in the Installaon Guide. Be sure not to use heat to disassemble any

axle components. To do so can adversely eect the properes of materials and weaken

or distort components.

Bent axles, more easily damaged prior to installaon of the Powertrax No-Slip Tracon

System, are not uncommon and may be dicult to visually detect. The Powertrax No-

Slip Tracon System is less forgiving of a bent axle. It is advisable to closely inspect the

straightness of the axles during installaon. A bent axle may cause excessive wear of the

Powertrax No-Slip Tracon System components which could lead to a malfuncon.

During installaon, be sure to inspect the “dierenal case” (somemes referred to as

the “carrier”), the “ring” and “pinion gears” and the “side gear” “thrust washers”. It is

unusual for these to be excessively worn or damaged, however, a thorough inspecon is

highly recommended to ensure the overall integrity of the dierenal. Any worn or dam-

aged component should be replaced. Do not drive the vehicle with any damaged driveline

components.

Thoroughly test your new Powertrax No-Slip Tracon System aer installaon by follow-

ing the test procedures in the Installaon Guide. Should you wish to periodically check

for proper operaon, test to verify that both wheels are driving properly and dierenat-

ing as required. Make this test under load, so that engine torque is applied through the

Powertrax No-Slip Tracon System with the wheels on the ground. Select a at surface

with good tracon and drive the vehicle in right and le circles make sure that the outside

wheel is free to overrun and that the outside re does not scu. Drive safely! Perform

this test in forward and reverse. You may wish to periodically repeat the test instrucons

in the Installaon Guide. Any anomaly in the test should be thoroughly invesgated and

corrected prior to placing the vehicle back into service.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Sin comentarios

Powertrax No-Slip Traction System User Manual Manual de usuario Pagina 21